DTC U3000:00 [EMERGENCY CALL UNIT]
id0902s6127500
Outline
|
System malfunction location |
Emergency call unit internal malfunction |
||||
|---|---|---|---|---|---|
|
Detection condition
|
• The emergency call unit detects internal malfunction.
|
||||
|
Fail-safe
|
Not applicable
|
||||
|
Possible cause
|
• Emergency call unit malfunction
|
||||
|
System wiring diagram
|
Not applicable
|
||||
|
Connector diagram
|
Not applicable
|
||||
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
INSPECT EMERGENCY CALL UNIT FOR MALFUNCTION DEPENDING ON REPEATABILITY
• Clear the DTC recorded in the memory.
(See CLEARING DTC.)
• Perform the DTC inspection for the emergency call unit.
(See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, replace the emergency call unit and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification
|
VERIFY IF OTHER DTC IS DISPLAYED
• Perform the DTC inspection.
(See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|